29-04-2018, 09:20 AM
(28-04-2018, 01:57 PM)JonE Wrote: I think the consensus that it was the same as BP28...
Out if interest, why do you think its too short and by how much? I was wondering with mine [that is now on a late type 3 SWB axle and thus should be back to 20] whether 19.5 will be fine anyway, as presumably it jsut puts wear into a slightly different part of the carden block.
byut I'm not sure.
I think it's too short because the Carden blocks are sticking out the front of the housing. I'd say the prop is about 1/2 inch short to put the blocks at about the middle of the housing but when I measured it yesterday it seems to be the longer 20 inch one hence the question about the BP93. The car is fitted with 3 speed gearbox with speedo drive and Type 3 back axle but should have the Type 2 with screw in torque tube. Thanks for the advise, going to double check the length again today.