09-02-2021, 09:13 AM
(This post was last modified: 09-02-2021, 09:48 AM by Howard Wright.)
Hi Austin
Thanks. I must admit that I could measure the one on either my RK or Special but both are on the car and I’m being a bit lazy
.
The reason for my request is that I have an OK short nose one from a later car (RP without the thread) and I intend turning an extension with a thread and welding it onto the shorter nose cone.
Thanks for the prompt response
Cheers
Howard
Oooops
Just realised that the later RP nose cone is too narrow to take the collar on the earlier shaft.
Back to the drawing board
.
Cheers
Howard
Thanks. I must admit that I could measure the one on either my RK or Special but both are on the car and I’m being a bit lazy
.The reason for my request is that I have an OK short nose one from a later car (RP without the thread) and I intend turning an extension with a thread and welding it onto the shorter nose cone.
Thanks for the prompt response
Cheers
Howard
Oooops
Just realised that the later RP nose cone is too narrow to take the collar on the earlier shaft.
Back to the drawing board
.Cheers
Howard