27-03-2020, 07:56 PM
very interesting Chris - so perhaps Barry's 2006 post was a little bit wrong. The chap on ebay had misread the code (or at least completely misquoted it) but fortunately the picture on the side of the unit revealed.
The 7-8.5 degrees is presumably a wider catch-all, or a more rigorous appraisal of their action, 15 years further on...
Any advice on drilling for end gear? I was thinking it would be possible using an old gear as a guide, but is an easy enough job or an engineers one?
The 7-8.5 degrees is presumably a wider catch-all, or a more rigorous appraisal of their action, 15 years further on...
Any advice on drilling for end gear? I was thinking it would be possible using an old gear as a guide, but is an easy enough job or an engineers one?