04-12-2019, 10:25 AM
ok, so looking at the frame, which is the best side of the holes to join? i.e. is it perfectly acceptable to solder on the inner side of the frame so there is less perimeter of gauze/solder and a smaller gauze overall? Or does the gauze being physically held by the set screws offer some additional safety?
I noticed when disassembling that it is quite possible to leave the original solder positions where they are and just detach the old gauze. (Not so easy on the bit round the edge). Presumably this makes it easier to add a bit of solder to the existing positions and then add the gauze, rather than re-tinning everything?
I noticed when disassembling that it is quite possible to leave the original solder positions where they are and just detach the old gauze. (Not so easy on the bit round the edge). Presumably this makes it easier to add a bit of solder to the existing positions and then add the gauze, rather than re-tinning everything?