11-05-2019, 06:04 PM
thankyou. I have tried to find the other thread but no joy, if others know...
incidentally, Ian Moorcroft adds: "The bottom of frame to scuttle [on my RF] is the same as Howards drawing: 2” in the centre tapering to 1 3/4” on the ends. Its strange this taper as it's always bugged me that it should have been parallel and a mistake on my part during my rebuild in the 70s."
So some have taper, and some have not...?
incidentally, Ian Moorcroft adds: "The bottom of frame to scuttle [on my RF] is the same as Howards drawing: 2” in the centre tapering to 1 3/4” on the ends. Its strange this taper as it's always bugged me that it should have been parallel and a mistake on my part during my rebuild in the 70s."
So some have taper, and some have not...?