08-02-2019, 09:31 PM
Having just completed the overhaul of my 4 speed (3 synchro) gearbox I find that the thread on the end of the 3rd motion shaft for the drive shaft flange is damaged, the nut is also damaged but I think the shaft thread will clean up with the correct die.
Can somebody please tell me what this thread is so that I can obtain the correct die, it looks to be 5/8" x 16 tpi which suggests it could be whitform but I would welcome confirmation of this. I'll also be looking for a replacement nut but I haven't found one listed on any of the usual suppliers parts lists, could anybody point me in the right direction??
Many thanks, ..... Phil.
Can somebody please tell me what this thread is so that I can obtain the correct die, it looks to be 5/8" x 16 tpi which suggests it could be whitform but I would welcome confirmation of this. I'll also be looking for a replacement nut but I haven't found one listed on any of the usual suppliers parts lists, could anybody point me in the right direction??
Many thanks, ..... Phil.