The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.32 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval



Austinsevenfriends › Austin Seven Friends Forum › Forum chat... v
U joint woes

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
U joint woes
Tony Press Offline
Older Member
*****
Joined: Aug 2017 Posts: 1,790 Threads: 43
Reputation: 15
Location: Malvern, Victoria, Australia
#12
06-07-2018, 05:59 AM
(06-07-2018, 05:10 AM)Erich Wrote: Thank you Simon. Noted that square edge goes to the inside.

Erich in Seattle

There seem to be two opinions on the insertion of a circlip - I would have thought that if the groove is cut cleanly then facing the 'flat' side of the circlip away from the thrust might be preferable.
http://austin7club.org
Reply


Messages In This Thread
U joint woes - by Erich - 03-07-2018, 02:32 AM
RE: U joint woes - by bob46320 - 03-07-2018, 06:28 AM
RE: U joint woes - by Dave Wortley - 03-07-2018, 07:26 AM
RE: U joint woes - by Chris KC - 03-07-2018, 07:49 AM
RE: U joint woes - by Jeff Taylor - 03-07-2018, 12:30 PM
RE: U joint woes - by Chris KC - 03-07-2018, 01:21 PM
RE: U joint woes - by Jeff Taylor - 04-07-2018, 02:06 AM
RE: U joint woes - by Erich - 04-07-2018, 03:48 AM
RE: U joint woes - by "Slack Alice" Simon - 04-07-2018, 09:16 PM
RE: U joint woes - by Chris KC - 05-07-2018, 07:52 AM
RE: U joint woes - by Erich - 06-07-2018, 05:10 AM
RE: U joint woes - by Tony Press - 06-07-2018, 05:59 AM
RE: U joint woes - by "Slack Alice" Simon - 06-07-2018, 07:54 AM
RE: U joint woes - by Erich - 06-07-2018, 08:46 PM
RE: U joint woes - by Phil Kingdom - 06-07-2018, 09:09 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)