27-06-2018, 05:02 AM
(This post was last modified: 27-06-2018, 05:03 AM by Bob Culver.)
Hi Mark
That is very pretty. For many there is more satisfaction in such work than driving the car, and it is safer!
Presumably you used a round end end mill. but the original seem to have squared ends. How do you reckon those were machined? Or have they just worn to square ends?
Are the inserts semi circular? If not how were the rounded ends prepared?
That is very pretty. For many there is more satisfaction in such work than driving the car, and it is safer!
Presumably you used a round end end mill. but the original seem to have squared ends. How do you reckon those were machined? Or have they just worn to square ends?
Are the inserts semi circular? If not how were the rounded ends prepared?