The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.31 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval



Austinsevenfriends › Austin Seven Friends Forum › Forum chat... v
Engine mounts

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Engine mounts
Ian Williams Offline
Freak
*****
Joined: Aug 2017 Posts: 1,715 Threads: 47
Reputation: 25
Location: Auckland NZ
Car type: 36 Nippy, 31 RM, 38 Special, 24 Works Rep
#3
20-11-2024, 01:03 AM
There was once a steel ring/washer around the hex nut, most of the time these have been lost at some point in the distant past and as Robert mentions the rubbers just compress over them. I find the newly supplied rubber bolt sleeves are a bit of a compromise in size and consequently a difficult fit, silicon grease helps here. The studs should be 3/8" diameter.
Black Art Enthusiast
Reply


Messages In This Thread
Engine mounts - by timbigden@icloud.com - 19-11-2024, 05:08 PM
RE: Engine mounts - by Robert Leigh - 19-11-2024, 05:45 PM
RE: Engine mounts - by Ian Williams - 20-11-2024, 01:03 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)