The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.31 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval



Austinsevenfriends › Austin Seven Friends Forum › Forum chat... v
29 to 30 Starting handle nut thread

Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
29 to 30 Starting handle nut thread
Howard Wright Offline
Grey Mag editor
*****
Joined: May 2018 Posts: 2,121 Threads: 111
Reputation: 22
Location: Llandrindod Wells
Car type: 29 Special, 30 RK, 28 C Cab
#1
08-02-2021, 08:29 PM
Hi All

Could anyone let me know the thread size on the securing nut that holds the starting handle shaft to the nose cone on a 1929 or 1930 car?  

Cheers

Howard
Reply
Austin in the Shed Offline
Senior Member
****
Joined: Aug 2017 Posts: 641 Threads: 29
Reputation: 7
#2
08-02-2021, 10:49 PM
Without going out and measuring one I think it's  1 1/4"x16tpi
Reply
Howard Wright Offline
Grey Mag editor
*****
Joined: May 2018 Posts: 2,121 Threads: 111
Reputation: 22
Location: Llandrindod Wells
Car type: 29 Special, 30 RK, 28 C Cab
#3
09-02-2021, 09:13 AM (This post was last modified: 09-02-2021, 09:48 AM by Howard Wright.)
Hi Austin

Thanks.  I must admit that I could measure the one on either my RK or Special but both are on the car and I’m being a bit lazy Big Grin.

The reason for my request is that I have an OK short nose one from a later car (RP without the thread) and I intend turning an extension with a thread and welding it onto the shorter nose cone.

Thanks for the prompt response 

Cheers

Howard
Oooops

Just realised that the later RP nose cone is too narrow to take the collar on the earlier shaft. 

Back to the drawing board Smile.

Cheers

Howard
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)