When trying to remove one of the circlips on the propshaft joint, it snapped. I now have just over half of it left in situ with neither of the holes in the ends left. I have managed to remove everything else from the joint, though.
In trying to get the remains of the clip out, I have tried snapping it with a chisel, gripping it with pliers and pushing it out. So far, all I have succeeded in doing is to chase it around the groove.
Does anyone have any suggestions how to remove it, please? I am considering cutting it with a Dremel as a last resort, but I do not want to nick the actual joint casting if I can avoid it.
Jamie.
In trying to get the remains of the clip out, I have tried snapping it with a chisel, gripping it with pliers and pushing it out. So far, all I have succeeded in doing is to chase it around the groove.
Does anyone have any suggestions how to remove it, please? I am considering cutting it with a Dremel as a last resort, but I do not want to nick the actual joint casting if I can avoid it.
Jamie.