16-10-2023, 03:52 PM
Thanks Chris...
The reason a number of prototypes were made was to get to the 'ideal' angle of the triangular fillet to get to the point where the rubber seal would press down on the rear part of the roof. It looks a little flat in the photo, but that maybe becuase I have made the tail a little too long and I need to shorten it a little. It does seem to remain in contact with the roof as I slide the panel back and forth so I may be over-thinking this. But , as is always the case, at this point it is as easy to get it right as wrong.
The reason a number of prototypes were made was to get to the 'ideal' angle of the triangular fillet to get to the point where the rubber seal would press down on the rear part of the roof. It looks a little flat in the photo, but that maybe becuase I have made the tail a little too long and I need to shorten it a little. It does seem to remain in contact with the roof as I slide the panel back and forth so I may be over-thinking this. But , as is always the case, at this point it is as easy to get it right as wrong.