20-09-2023, 10:15 PM
(This post was last modified: 20-09-2023, 10:19 PM by Tony Griffiths.)
As this is a non-standard installation the only suggestion I can make is to keep it as short as possible and well-clipped down. I'd experiment with a more flexible cable to see what route is possible: perhaps up the firewall, then across it (just above the engine), then down and through it at a point that would line it up with the original floor-mounted switch - if you still have that fitted - and then to the battery? You might be able to run it along the inside face of the firewall, but as the proper cable is very stiff, getting it the bend inwards (through the firewall) and then immediately towards the passenger side would be difficult.