31-07-2023, 02:04 PM
(This post was last modified: 15-08-2023, 08:02 PM by Tony Griffiths.)
This PDF might help: http://www.da7c.co.uk/technical_torque_a...Wiring.pdf
Wiring each bulb back to the battery is a good idea on 6 volts - but probably not essential on 12 to get the brightest indicators.
Lots of information on problems with interference with LED bulbs and flasher units in the forum search - but on a 12-volt system you'll probably be happy with just an ordinary set-up.
If you want an "original-looking" wire, a cotton-covered modern one is available: https://www.autoelectricsupplies.co.uk/p...core-cable
Original-type armoured cable can, of course, be obtained from our unusual suppliers: https://www.theaustinsevenworkshop.com/c...cal-wiring
Wiring each bulb back to the battery is a good idea on 6 volts - but probably not essential on 12 to get the brightest indicators.
Lots of information on problems with interference with LED bulbs and flasher units in the forum search - but on a 12-volt system you'll probably be happy with just an ordinary set-up.
If you want an "original-looking" wire, a cotton-covered modern one is available: https://www.autoelectricsupplies.co.uk/p...core-cable
Original-type armoured cable can, of course, be obtained from our unusual suppliers: https://www.theaustinsevenworkshop.com/c...cal-wiring