25-04-2018, 09:48 PM
Hi Stephen,
My advise would be fit the new shells in the block and have who ever is doing the Grinding to measure,
Reason for this is they are mass produced and there will be tolerances, also the housing could be out of round.
Every ones feel with a Micrometer is different especially going from inside to outside.
Do not assume the shells and housing are correct Check
Colin
NZ
My advise would be fit the new shells in the block and have who ever is doing the Grinding to measure,
Reason for this is they are mass produced and there will be tolerances, also the housing could be out of round.
Every ones feel with a Micrometer is different especially going from inside to outside.
Do not assume the shells and housing are correct Check
Colin
NZ