04-07-2023, 11:03 PM
(04-07-2023, 05:23 PM)Stuart Giles Wrote: It's a very long time since I worked on a Bowdenex setup, but IIRC, they used a special nut that had a machined rebate on the Bowdenex supplied radius arm nuts. the rebate was a close fit in the hole in the front sandwich plate leaving the hexagon on the outside. This was necessary because the two plate sandwich increased the thickness such that a factory nut couldn't pull up on the radius arm thread. ISTR the thread is 5/8 x 16 WF, as per the halfshafts.
Thanks Stuart
I knew I had a couple somewhere... mixed up with some Speedex wheel nuts... Hugh also sent me a drawing showing the original nut design. Definitely another victory for the Archive!
Screenshot_20230704-225458_Gallery.jpg (Size: 131.81 KB / Downloads: 101)