08-05-2023, 03:59 PM
The rods in your picture look to be the right ones, and they look as though they may have had some crack test fluid sprayed on the little end. This would be where any crack usually develops. If you buy these rods I suggest using new big end bolts and self locking nuts, which allow exactly the correct torque to be applied, and also new HT little end bolts. It may well be that the big ends require re-metalling to fit the journal size of your crankshaft. If they are too small it may be possible to machine to fit the shaft without re-metalling, or a skilled person could scrape them to fit.