19-04-2018, 05:22 AM
Well Colin Rory is probably the man with most experience of fitting these so I am sure he will comment if there is anything I have missed or that he disagrees with here. The main thing as already mentioned is cleanliness, I use brake cleaner to ensure there are no traces of oil or grease, and as with any joint check the faces are flat and free from burrs. Tighten the base nuts down evenly a bit at a time, diametrically opposite much like you would on a cylinder head, once tight you will find the gasket has spread a little as it compressed, I trim any excess with a craft knife. As Rory mentioned in his earlier comments, recheck all nuts after leaving it to settle overnight, but thats it I can not think of anything else to be aware of.
Black Art Enthusiast