20-02-2023, 01:09 AM
(This post was last modified: 20-02-2023, 01:10 AM by Duncan Grimmond.)
Steve, the funnel extension sounds like a good idea, what would one look like? Is that a pic of a J.A.R one (or Eversure on a Chummy) a bit further up this page (1), in cast aluminium? If not, do you have pics of a worked example? Dimesions? I'm not at all familiar with the magneto engine...
I assume it would need a seal of some sort, perhaps an O ring in a groove?
I assume it would need a seal of some sort, perhaps an O ring in a groove?