01-02-2023, 12:24 PM
You can machine the reverse gate slot deeper to remove the need to lift up the lever.It is quite hard to engage reverse while moving forward. I did the above and had no problem.
You would need to do similar if using an eltos,or bad engineeringly shorten the selector rod to clear the reverse gate slot if that makes sense.
It is possible to deepen the gate slot while assembled but need plenty of rag inside.
You would need to do similar if using an eltos,or bad engineeringly shorten the selector rod to clear the reverse gate slot if that makes sense.
It is possible to deepen the gate slot while assembled but need plenty of rag inside.