10-04-2018, 03:04 PM
What I have heard is that 12 volts causes the starter to engage much more violently. Additionally, I should add that the bolt which was loose is a skinny 3/16ths longer that the one on the other side and had been cut down from a longer bolt. Are these supposed to be unequal length as on the bacon slicer type? If not then that may have been the culprit. Perhaps someone bottomed the bolt out then continued to tighten. Or does the original tapped hole not have a bottom? So if the 12 volt system is the culprit, should I convert back to 6 volt?
Erich in Seattle
Erich in Seattle