27-11-2022, 03:15 PM
Nick: the only place that these might fit is around or near the rear tunnel area where the body sits at a higher level. The metal is thin 19 gauge (I think) and the hole spacing would have to match existing pre-punched holes in the parts there. My thoughts are that they are packing to bring the levels of two different parts to the same height ...but where ?
Malcolm: they might but there is no reference to these being used for this. I'll keep this in mind though.
I suspect they were to be used in this area of the floor pan but they didn't seem to match any of the hole spacing for the rivets. If they are redundant i don't think they'll affect anything.
Cheers,
Stephen
Malcolm: they might but there is no reference to these being used for this. I'll keep this in mind though.
I suspect they were to be used in this area of the floor pan but they didn't seem to match any of the hole spacing for the rivets. If they are redundant i don't think they'll affect anything.
Cheers,
Stephen