25-10-2022, 08:18 PM
Hi Vancevr
Finding these bits is difficult. I had to make the adjusting screw and quadrant but luckily I had the the brass bit.
The screw thread is, I think from memory 5/16”, and can be made from a long set screw. I made up the quadrant on the lathe then cut and drilled it. (My turned one on left and an original from my RK on the right).
FC1E9B67-66F5-479A-AA0D-29B4A39D57CA.jpeg (Size: 110.91 KB / Downloads: 372)
I think the brass part may be more complex but I don’t think dimensions are critical so you or a machinist may be able to fabricate it from a solid piece.
Cheers
Howard
Finding these bits is difficult. I had to make the adjusting screw and quadrant but luckily I had the the brass bit.
The screw thread is, I think from memory 5/16”, and can be made from a long set screw. I made up the quadrant on the lathe then cut and drilled it. (My turned one on left and an original from my RK on the right).
FC1E9B67-66F5-479A-AA0D-29B4A39D57CA.jpeg (Size: 110.91 KB / Downloads: 372)
I think the brass part may be more complex but I don’t think dimensions are critical so you or a machinist may be able to fabricate it from a solid piece.
Cheers
Howard