15-07-2022, 08:36 AM
Robert - the stump is 0.4 of an inch, but looking at another 35M it also looks shorter now than an original. So presumably its going to end up as a 3/8, the same as the other end? But that would entail it being put on a lathe in the first place....?
John - I wanted to look inside before considering anything else i.e. the condition of the bearing. I may just use the dynamo case and swap the middle out.
John - I wanted to look inside before considering anything else i.e. the condition of the bearing. I may just use the dynamo case and swap the middle out.