06-06-2022, 01:41 PM
Locktite 243 blue nutlock works OK a bit heat will release it, the lockwasher can also foul the centre of the clutch plate. If the oilseal plate touches the flywheel use the thin gaskets skim the face of the plate and set the seal in a little deeper. You can measure the flywheel boss to rear bearing clearance by fitting the flywheel without the key and use the vernier depth gauge through the keyway slot then remove and measure nut face to back of boss subtract one from the other gives you accurate clearance measurement to allow for the oil thrower that you need even with an oil seal fitted. Terry.