As oscillation dampers, the amount of damping is controlled by the coil spring compression on the friction plates and moving brass discs.
That would indicate that the spring pin and the link pin should be allowed some movement within the rubber bushes, albeit not loose, to allow for movement at the other end of the arm?
That would preclude forcing the excess rubber being squashed almost flat against the link and no fibre washers being included, so that the pins are ceased solid within the bushes?
That would indicate that the spring pin and the link pin should be allowed some movement within the rubber bushes, albeit not loose, to allow for movement at the other end of the arm?
That would preclude forcing the excess rubber being squashed almost flat against the link and no fibre washers being included, so that the pins are ceased solid within the bushes?