05-06-2022, 09:12 AM
(This post was last modified: 05-06-2022, 09:15 AM by David Stepney.)
No. The flywheel fits to the crank with a taper. If the flywheel has been loose for any length of time. it will have fretted on the end of the crank. I would remove the flywheel and examine the crank, the taper hole in the flywheel and the key and keyways for signs of damage. Damage to the taper can be corrected by lightly grinding the flywheel and crank together with a bit of grinding paste. GO CAREFULLY! It is surprising how quickly metal is removed. A smear of engineers blue on the crank will tell you where the high spots are. You need a good even fit along the taper lands. Remember that there is a gap in the centre of the taper face in the flywheel.
When lapping the flywheel, , do it without the oil thrower that lives behind it and against the rear main bearing and check that there is a gap between the flywheel and the inner race of the rear main bearing. It the flywheel does go up[ against the rear main, then the taper will not grip properly.
Finally, do not be tempted to Loctite the flywheel to the taper!! You might be the unfortunate person to try and get it off again!
Fit a new key. New keys are available form cherished suppliers and, when you are happy with the fit of the flywheel onto the crank, replace the oil thrower and tighten the nut to about 150 ft/lbs.
When lapping the flywheel, , do it without the oil thrower that lives behind it and against the rear main bearing and check that there is a gap between the flywheel and the inner race of the rear main bearing. It the flywheel does go up[ against the rear main, then the taper will not grip properly.
Finally, do not be tempted to Loctite the flywheel to the taper!! You might be the unfortunate person to try and get it off again!
Fit a new key. New keys are available form cherished suppliers and, when you are happy with the fit of the flywheel onto the crank, replace the oil thrower and tighten the nut to about 150 ft/lbs.