Original ulster engine rebuild

[Tony Betts]

I dont mind you all having a laugh at my expense.

As this was my day.

Although it's a bank holiday, and I should have been working on the supersport. It didnt work that way.

I got some order out I had to do in the morning, and jubilee celebrations in the afternoon.

But inbetween time I dont this stoopid episode.

First I picked out an old stock gasket to copy for the bassis of making a 10 stud gasket.

I dont know who made it, but if you ever see another. RUN . Its miles out. Shown below.

   

---

So I pulled one of my own out, that does fit.

And it shows how far out the blue one is.

Showing below.

   

---

This is were the stupidity started.

I drew out the holes, and edges for the gasket. Left some over on the ends, for the 2 extra studs.

Only to find the 10 stud block is wider than the standard. 

So the gasket wasnt wide enough.

Shown below.

   

---

Now if that wasnt stoopid enough, watch this.

I cut a hole NEW gasket, and left enough on the side to cover the extra width of the gasket.

Shown below.

   

---

If you havent twigged it yet.

This idiot added the extra material to the wrong side of the block