16-03-2018, 06:50 PM
well observed!
With the length of the carden socket being 3" or so, then one might assume that 1/2" variation could allow generic use when replacement became due.
Where should the carden blocks 'sit' in the joint/socket when fitted on level ground/car not weighted?
Perhaps we now need to measure axle to carden joint lengths on the three types of axle.
With the length of the carden socket being 3" or so, then one might assume that 1/2" variation could allow generic use when replacement became due.
Where should the carden blocks 'sit' in the joint/socket when fitted on level ground/car not weighted?
Perhaps we now need to measure axle to carden joint lengths on the three types of axle.