EA Body supports

[Erich]

Henry, I am a little confused, so perhaps you could clarify. There are four supports in total. Two are riveted to the front cross member, taking three rivets each. The part that rivets to the cross member is triangular in pattern. Then there is a bent part rectangular in pattern that goes under the floor on either side of the g/b. These have a single hole to take a bolt and nut. On the body itself, there are two rectangular pieces with a bend in the middle. They are riveted to the floorpan and the angled firewall. There are four rivets on the angled part of the firewall and three rivets on the floor bit. There is a larger hole on the floor pan bit which takes the bolt and nut which attach these pieces to the pieces which are riveted to the chassis cross piece. On genuine Ulsters(EA Sports), the pieces that are under the floorpan are angled to the front, whereas on most Replicas, the body is further back so the bit that goes under the floorpan projects to the rear. Additionally, there are supports on the outboard end of the chassis cross piece, but I don't think you are referring to these. Erich in Mukilteo