14-03-2022, 07:57 PM
Hi oxford,
Have you checked to see if it is tight in the stub before fitting in the axle.
If the axle eye has no wear, then the kingpin shouldn't bend the cotter then pushes it up against a flat edge. Unless you put a huge amount of pressure on the cotter.
Often the stub will go tight and loose when turning, because the surfaces between the bush and axle are not flat.
Have you checked to see if it is tight in the stub before fitting in the axle.
If the axle eye has no wear, then the kingpin shouldn't bend the cotter then pushes it up against a flat edge. Unless you put a huge amount of pressure on the cotter.
Often the stub will go tight and loose when turning, because the surfaces between the bush and axle are not flat.