09-03-2022, 04:41 PM
(This post was last modified: 09-03-2022, 04:43 PM by Stuart Giles.
Edit Reason: missing word
)
The peg is there in original fit roller bearing axles to stop the 5/8" width roller race outer ring/track wandering towards the crown wheel. If you are going to use the 3/4" wide ball race, then just remove the peg. If you are going to use a 3/4" wide roller race you will probably need to cut back this peg, or even remove it to allow enough room to seat the wider outer track.
All the rear axles I have done which had a 1" pinion have either had a 1" bore sleeve Loctited into the late style 1 1/8" roller race, or have had a 1 1/8" OD sleeve Loctited onto the pinion to accept the roller race.
All the rear axles I have done which had a 1" pinion have either had a 1" bore sleeve Loctited into the late style 1 1/8" roller race, or have had a 1 1/8" OD sleeve Loctited onto the pinion to accept the roller race.