02-03-2022, 03:19 AM
I am making progress with my car, and many thanks to this forum for all it's helpful advice. I tried to find something on this subject but without luck, so apologies if I'm asking something that has been covered elsewhere.
I am working on the upholstery and doing the "easy" stuff first. I am puzzled about the two vertical slots in the plywood door panels.
They seem to be at each side of the pocket, and I found a small piece of the rubber band that clearly went through the top of the panel on each side.
I was going to make the pocket and the two side panel sections all in one piece, and now I wonder if that should include a strengthening flap going through the pocket to protect against the pocket and contents causing the rest of the panel covering to sag.
I hope that I have succeeded in attaching a picture of the panel remains and the car.
Any advice is welcome.
I am working on the upholstery and doing the "easy" stuff first. I am puzzled about the two vertical slots in the plywood door panels.
They seem to be at each side of the pocket, and I found a small piece of the rubber band that clearly went through the top of the panel on each side.
I was going to make the pocket and the two side panel sections all in one piece, and now I wonder if that should include a strengthening flap going through the pocket to protect against the pocket and contents causing the rest of the panel covering to sag.
I hope that I have succeeded in attaching a picture of the panel remains and the car.
Any advice is welcome.
Slowly rebuilding a '34 RP