28-02-2022, 01:30 PM
just unearthing an old thread... the BIG inner nut must be the 1 11/16" not 1 1/4" as Tony suggests?
I've noticed that the position washer tab - curved rather than coming to a point - sits into the divot on the end of the axle side tube, but doesn't position particularly well - its easy for it move sideways. I'm presuming it must only secure down on the inner parts of the bearing and no contact with the outer bit. Have I perhaps got the wrong washers?
I've noticed that the position washer tab - curved rather than coming to a point - sits into the divot on the end of the axle side tube, but doesn't position particularly well - its easy for it move sideways. I'm presuming it must only secure down on the inner parts of the bearing and no contact with the outer bit. Have I perhaps got the wrong washers?