22-12-2021, 05:39 PM
Hi All
I’ve spent an hour or so in the garage today escaping from Christmas preparation duties. In that time I’ve fully dismantled a DJ4 distributor and after the bits were cleaned in my ultrasonic cleaner I’m ready to reassemble.
I was fully prepared to buy a new cap but I have about three that look in quite good shape so two of them went in the cleaner and have come out clean but with a matt finish. I guess I’ll have to wait until they are on the car to be sure they work.
However any hints tips etc on how to bring them back to their shiny original condition without ruining the electrical insulation properties?
Cheers
Howard
I’ve spent an hour or so in the garage today escaping from Christmas preparation duties. In that time I’ve fully dismantled a DJ4 distributor and after the bits were cleaned in my ultrasonic cleaner I’m ready to reassemble.
I was fully prepared to buy a new cap but I have about three that look in quite good shape so two of them went in the cleaner and have come out clean but with a matt finish. I guess I’ll have to wait until they are on the car to be sure they work.
However any hints tips etc on how to bring them back to their shiny original condition without ruining the electrical insulation properties?
Cheers
Howard