15-12-2021, 12:14 AM
hi Guys
a note from Australia.
when fitting a tonneau to a Chummy why not simply make a sleeve that fits over the windscreen. if this is made to the full height & width of the screen with some additional overlap on each side it will only be necessary to attach some bungy cord ties at the rear end to fit over the folded hood.
this method avoids the need for any additional fasteners.
if the tonneau is to be split along the centreline to enable the driver position to remain available the sleeve over the screen can be split centrally with Velcro tape in the overlap.
the side overlap will cover the edge of the body.
all in all a simple solution that does not require additional fasteners and can be removed completely when not needed.
have fun
Bernard
a note from Australia.
when fitting a tonneau to a Chummy why not simply make a sleeve that fits over the windscreen. if this is made to the full height & width of the screen with some additional overlap on each side it will only be necessary to attach some bungy cord ties at the rear end to fit over the folded hood.
this method avoids the need for any additional fasteners.
if the tonneau is to be split along the centreline to enable the driver position to remain available the sleeve over the screen can be split centrally with Velcro tape in the overlap.
the side overlap will cover the edge of the body.
all in all a simple solution that does not require additional fasteners and can be removed completely when not needed.
have fun
Bernard