14-12-2021, 03:46 PM
I do not like putting holes where they don't already exist.
The cover on the Cambridge fits over two Lift a Dots at the back, and has two elastic straps with plastic hooks on, whick clip over the mudguard stays at the front.
The Tourer one isn't finished yet.
I'm not sure what I will do at the rear, the hood is still fitted. If the hood wasn't fitted, there are existing screw holes to use.
The front has the elastic/hook arrangement.
The middle will be supported on a light bar that follows the contours of the seat backs, and has a vertical leg each end, which will drop into the side screen holes.
Which means it can be folded back under itself, so covering the rear compartment only.
The cover on the Cambridge fits over two Lift a Dots at the back, and has two elastic straps with plastic hooks on, whick clip over the mudguard stays at the front.
The Tourer one isn't finished yet.
I'm not sure what I will do at the rear, the hood is still fitted. If the hood wasn't fitted, there are existing screw holes to use.
The front has the elastic/hook arrangement.
The middle will be supported on a light bar that follows the contours of the seat backs, and has a vertical leg each end, which will drop into the side screen holes.
Which means it can be folded back under itself, so covering the rear compartment only.