07-12-2021, 06:20 PM
Hi all. I hope you are coping ok with your winter weather.
Since this topic is about working Dynamos, I would like to ask those of you in the know about the best way to repair the rear end frame damage where the bearing is normally pressed in. The casting looks like cast iron.
If I can't find a way to repair the damage, I'll need to find a good serviceable replacement for the end frame. I'm not sure but according to the Woodrow I am missing the large thin steel washer which appears to go under the brush holders. I'm also missing the oil slinger at the front. All part of the legacy of the previous owner's servicing I'm guessing.
Cheers,
Stephen
Since this topic is about working Dynamos, I would like to ask those of you in the know about the best way to repair the rear end frame damage where the bearing is normally pressed in. The casting looks like cast iron.
If I can't find a way to repair the damage, I'll need to find a good serviceable replacement for the end frame. I'm not sure but according to the Woodrow I am missing the large thin steel washer which appears to go under the brush holders. I'm also missing the oil slinger at the front. All part of the legacy of the previous owner's servicing I'm guessing.
Cheers,
Stephen