30-11-2021, 09:21 PM
HI All,
Providing the thread has a smaller Dia than the taper there is no way it should be damaged.
damage is caused by using the cotter as a means of lining up the shaft you are trying to locate by bashing it in with a hammer
then they have problems fitting the nut as they have damaged the thread
very poor workman ship take you time and do it right
Colin
NZ
Providing the thread has a smaller Dia than the taper there is no way it should be damaged.
damage is caused by using the cotter as a means of lining up the shaft you are trying to locate by bashing it in with a hammer
then they have problems fitting the nut as they have damaged the thread
very poor workman ship take you time and do it right
Colin
NZ