The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.31 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval




Thread Rating:
  • 28 Vote(s) - 3.32 Average
  • 1
  • 2
  • 3
  • 4
  • 5
What have you done today with your Austin Seven
Tried to assemble rear axle and chassis today, but had a feeling there is the slightest of bend detectable in the O/S tube. Did the N/S spring pin first, then could not get the spring pin into the final hub locator on the O/S, despite everything being slack.(pin fits in fine when spring not there, and fits fine through spring!) Was going to take a heavy duty ratchet strap tomorrow to see if I could pull something to get the last mm or so. Or disassemble everything and try and get the O/S done first. Any advice?
Reply


Messages In This Thread
Peak District well dressing - by Tony Griffiths - 31-08-2019, 05:00 PM
Genuine old and imitation new - by Tony Griffiths - 01-07-2021, 03:37 PM
RE: What have you done today with your Austin Seven - by JonE - 30-11-2021, 06:49 PM
Crankcase machining - by Chris Garner - 29-08-2023, 08:59 PM
Massed ballon landing and A7 - by Tony Griffiths - 03-09-2023, 08:27 PM
A beautiful evening drive - by Tony Griffiths - 19-09-2024, 10:16 AM
Popping and not pulling well? - by Biddlecombe - 10-04-2019, 03:37 PM

Forum Jump:


Users browsing this thread: 28 Guest(s)