06-11-2021, 10:02 PM
(06-11-2021, 06:09 PM)Nick Lettington Wrote: I couldn't get the LED bulbs needed for my bulb holders, so found two incandescent bulbs of the type needed on ebay and ripped the insides out. I then soldered short wires to the contacts of a pair of LED bulbs, drilled the solder in the emptied cap (from the inside out) and soldered the other ends of the wires through the holes. Setting the distance of the emitters to be level with the filaments in the original bulb, I then wedged the LED bulb into the cap with copper and filled the gap with hot melt glue. They work perfectly.
Thank you, Nick, that sounds like a reasonable solution.