25-10-2021, 07:11 AM
I am currently assembling a three speed box with all new gears and bearings and would appreciate some guidance on setting the first motion shaft. Obviously there is no positive longitudinal location for this gear, it seems that you set the output shaft in temporarily than press the first motion shaft in until there's minimal end float.
The balance of the set up seems to be well covered in the various publications.
Any further guidance would be greatly appreciated.
Jim Runciman
Perth, Australia
The balance of the set up seems to be well covered in the various publications.
Any further guidance would be greatly appreciated.
Jim Runciman
Perth, Australia