The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.31 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval



Austinsevenfriends › Austin Seven Friends Forum › Forum chat... v
Halfshaft failure

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Halfshaft failure
Stuart Giles Offline
Old Git
****
Joined: Aug 2017 Posts: 741 Threads: 8
Reputation: 11
Location: N W Kent
#19
20-10-2021, 04:01 PM
Failure of a factory Halfshaft at the Brinell test indentation was mentioned earlier in this thread. I had an object lesson in stress raisers caused by a sudden change in section some years ago with my Special.

[Image: 42562967442_c4a8c54169_z.jpg]

You can see part of the Brinell indentation on the broken end in the photo. What's not  so obvious is where I've blinded it out (the shiny area just behind the new keyway) in the short Halfshaft  that I created from a knackered long one above the broken end.
Reply


Messages In This Thread
Halfshaft failure - by Lowlevelandfast - 18-10-2021, 07:46 PM
RE: Halfshaft failure - by Robert Foreman - 18-10-2021, 08:32 PM
RE: Halfshaft failure - by Ian Williams - 18-10-2021, 08:34 PM
RE: Halfshaft failure - by Dave Mann - 18-10-2021, 08:43 PM
RE: Halfshaft failure - by Tony Betts - 18-10-2021, 08:52 PM
RE: Halfshaft failure - by Bob Culver - 18-10-2021, 09:36 PM
RE: Halfshaft failure - by Denis Sweeney - 18-10-2021, 10:09 PM
RE: Halfshaft failure - by Bob Culver - 18-10-2021, 10:35 PM
RE: Halfshaft failure - by dickie65 - 18-10-2021, 10:35 PM
RE: Halfshaft failure - by Bob Culver - 19-10-2021, 12:46 AM
RE: Halfshaft failure - by Denis Sweeney - 19-10-2021, 07:18 AM
RE: Halfshaft failure - by Chris KC - 19-10-2021, 07:58 AM
RE: Halfshaft failure - by Dave Mann - 19-10-2021, 08:48 AM
RE: Halfshaft failure - by Steve kay - 19-10-2021, 09:06 AM
RE: Halfshaft failure - by Bob Culver - 19-10-2021, 09:19 AM
RE: Halfshaft failure - by Colin Morgan - 19-10-2021, 02:26 PM
RE: Halfshaft failure - by Bob Culver - 19-10-2021, 07:44 PM
RE: Halfshaft failure - by Dave Mann - 20-10-2021, 10:12 AM
RE: Halfshaft failure - by Stuart Giles - 20-10-2021, 04:01 PM
RE: Halfshaft failure - by Bob Culver - 20-10-2021, 07:39 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)