22-02-2018, 12:53 PM
Presume when you say Rose Joints , you mean Rod Ends -Rose Joints are something slightly different.
I have done a couple of A7s with Rod ends on the steering I used 3/8" male rod ends threaded into home turned Bushes which were Nickel Bronze welded into the tube -I also put a peened over steel pin across the tube and bush at the very rear of the thread. the tube I used was 3/4" 16 SWG CDS.
"Off the peg" threaded bushes for rod ends are available from these people. http://stores.ebay.co.uk/McGill-Motorspo...7675.l2563
You might need a "high misalignment " style rod end at the steering arm end of the drag link/side tube-ordinary rod ends don't allow for a lot of "up and down" movement. something like this: https://www.autosport-bearings.co.uk/pro...ht-hand-2/
I have done a couple of A7s with Rod ends on the steering I used 3/8" male rod ends threaded into home turned Bushes which were Nickel Bronze welded into the tube -I also put a peened over steel pin across the tube and bush at the very rear of the thread. the tube I used was 3/4" 16 SWG CDS.
"Off the peg" threaded bushes for rod ends are available from these people. http://stores.ebay.co.uk/McGill-Motorspo...7675.l2563
You might need a "high misalignment " style rod end at the steering arm end of the drag link/side tube-ordinary rod ends don't allow for a lot of "up and down" movement. something like this: https://www.autosport-bearings.co.uk/pro...ht-hand-2/