26-09-2021, 11:21 AM
(This post was last modified: 26-09-2021, 11:27 AM by Duncan Grimmond.)
If you add wieght to the float will it not sink further and so exacerbate the problem? Or, am I upside down there? If the needle in the float is fixed rather than clipped and you want it to ride higher then a larger, more buoyant float is the only way.
I have adjusted the weight of brass floats in Amal pre-mono bloc carbs by using an electric soldering iron to sweat a little blob of solder to the float. Use an active flux like Baker's Fluid or Zinflo but be sure to wash it off well.
WARNING
*** Overheating it may cause the seam to split! ***
I have adjusted the weight of brass floats in Amal pre-mono bloc carbs by using an electric soldering iron to sweat a little blob of solder to the float. Use an active flux like Baker's Fluid or Zinflo but be sure to wash it off well.
WARNING
*** Overheating it may cause the seam to split! ***