05-09-2021, 04:04 PM
Been there, done that Chris 
The last ones I did, one pin came out with minimal effort, the second appeared to be laser welded 
When drifting out and heat fails, I've usually found the only remaining remedy is to cut the larger end of the pin off flush and, carefully (very), drill the rest out.
Steve
The last ones I did, one pin came out with minimal effort, the second appeared to be laser welded When drifting out and heat fails, I've usually found the only remaining remedy is to cut the larger end of the pin off flush and, carefully (very), drill the rest out.
Steve