16-08-2021, 12:14 PM
(This post was last modified: 16-08-2021, 12:16 PM by Steve Jones.)
Photos of the collar below, Howard. The one on the left is LH thread, that on the right RH thread. The dimensions are the same. O/A diameter: 63.0mm. Thread Depth 11.5mm. ID 49.0mm.
I've three cars with this type of axle and have all the parts to build two other axles. I have used the later roller race on one of my cars and rather than the standard peg, simply drilled and tapped through the banjo and inserted a suitable size and suitably modified bolt to retain the bearing outer.
Steve.
I've three cars with this type of axle and have all the parts to build two other axles. I have used the later roller race on one of my cars and rather than the standard peg, simply drilled and tapped through the banjo and inserted a suitable size and suitably modified bolt to retain the bearing outer.
Steve.