09-08-2021, 03:17 PM
Thanks all. Have had another look at body and seen floor/cill not as curved as I thought so will go with band sawing slightly wider section to fit the curve.
Currently have body upside down raised up on pallets, with poles between so can stand inside, removing paint from scuttle.
This is etch primer I put on a few years ago when started rebuild. Trying to get all bare metal so can go through full process to apply POR15. I never want to do this again!!!!!!!!
PS someYouTube vids advising how to get round sticking tin lids by drilling 2 holes and plugging with screws!!! then when next need to use just remove screws and pour out........they obviously missed the point that the pigment will have settled to the bottom and the paint should be stirred before use so will end up with rubish paint job that will not stay.
Dennis
Currently have body upside down raised up on pallets, with poles between so can stand inside, removing paint from scuttle.
This is etch primer I put on a few years ago when started rebuild. Trying to get all bare metal so can go through full process to apply POR15. I never want to do this again!!!!!!!!
PS someYouTube vids advising how to get round sticking tin lids by drilling 2 holes and plugging with screws!!! then when next need to use just remove screws and pour out........they obviously missed the point that the pigment will have settled to the bottom and the paint should be stirred before use so will end up with rubish paint job that will not stay.
Dennis