05-08-2021, 01:59 PM
(This post was last modified: 05-08-2021, 02:17 PM by Hedd_Jones.)
You could relieve the majority of the setscrew from the head say to the thread, or just above the thread, that would give you more clearance (aka wiggle room), it sounds to me like either the hole centres are different enough to bind, or perhaps the hole(s) in the case isn't tapped square.
If it were me, I would still like a full diameter portion at the case, motor housing interface. So as to give a better shear connection there.
Option 2 is fit a stud, assuming you can get the bacon slicer casing over it (which might not be possible).
If it were me, I would still like a full diameter portion at the case, motor housing interface. So as to give a better shear connection there.
Option 2 is fit a stud, assuming you can get the bacon slicer casing over it (which might not be possible).