04-08-2021, 01:48 PM
Is there not a suitable rod you could use?, bushed or reamed to utilize the Regal sized gudgeon pin. Not that I have ever used them, though I did recently pass a set on, are R4 rods not for 16mm gudgeon pins?. Be a doddle to bush one, assuming the end fits in the piston ok.
If you had access to a nice CNC mill, you could carve yourself 4 suitable conrods out of solid. Assuming you were happy to 'design' them also.
But I have to agree, buying pistons to fit would be the easiest way. I've still got to do a similar process here. But I do not have pistons (unless the ones still in the engine are ok).
If you had access to a nice CNC mill, you could carve yourself 4 suitable conrods out of solid. Assuming you were happy to 'design' them also.
But I have to agree, buying pistons to fit would be the easiest way. I've still got to do a similar process here. But I do not have pistons (unless the ones still in the engine are ok).